MTM Hydro 24.0063 is a stainless steel ⅜-inch quick-connect coupler for a pressure washer hose or spray gun inlet. Its female NPT thread fits over exposed male pipe threads. At the removable end, the sliding socket receives a matching ⅜-inch plug. This lets you disconnect the accessory while leaving its threaded joint in place.
To check fit, look at the two ends separately. At the permanent joint you need a ⅜-inch male NPT connection. At the quick-release joint, compare the size and profile of the existing plug with the MTM fitting. The word “female” describes the pipe thread. It does not identify whether the quick-release end is a socket or a plug. Pipe size is nominal, so a ruler measurement across the outside of the thread will differ from the size stamped on the fitting.
At a reel or gun, check the fitting on the hose before ordering. Hose inside diameter, pipe thread and quick-connect profile describe different features. A hose marked with the right diameter can still have a different end fitting.
NPT is a tapered pipe thread. If the other component uses BSP, metric or M22 threads, use an adapter specifically designed for those thread standards. A fitting that starts to turn by hand can still have an incompatible pitch or sealing surface. Thread sealant does not convert one thread system into another. Follow the equipment manufacturer’s recommendations for a compatible sealant at the threaded joint and keep the plug nose and the socket opening clean.
Before changing accessories, stop the pressure washer and release trapped pressure at the gun. Wipe grit from the quick connection, seat the plug fully and check that the socket collar has returned to its locked position. If the joint weeps after assembly, isolate and depressurize the system before inspecting it. The threaded joint and the seal inside the quick-connect socket are separate possible leak points.
Stainless steel suits frequently wetted fittings in a wash bay or mobile detailing setup. Inspect the socket seal and retaining mechanism periodically, particularly if the connection is opened for every wash. When replacing only one half of an existing pair, compare it with the mating plug and check the working pressure and temperature ratings of the complete hose, gun and accessory assembly.