Labocosmetica VERITAS Coating Prep & Polish Wipe Out 1L

Labocosmetica VERITAS Coating Prep & Polish Wipe Out 1L

Labocosmetica VERITAS Coating Prep & Polish Wipe Out 1L

Save $5.10
/
Labocosmetica

3%+ Discount with 3+ of the Same Item

3%+ Discount with 3+ of the Same Item

Shipping calculated at checkout.
  Ask about this product Add to Compare Products Add to Compare

Earn [points_amount] when you buy this item.

×

VÈRITAS is a swirls highlighter, essential before applying the coating or sealant, which cleans and can also be used in a innovative, as a check control of the life of the coating during the washing phase: in fact many shampoos leave micro-residues of surfactants that do not allow the coating to express itself at its best and which could thus make the detailer wrong who could mistakenly think that the coating has vanished. Thanks to #VÈRITAS this problem is totally avoided.

VÈRITAS can also be used as a lifeline during the application of a protective nano: in the event that some residue should be left, or the treated surface is particularly sensitive to the passage of the nano, #VÈRITAS it will eliminate all traces of product in a simple way and will allow you to repeat the operations. 

Directions:

VÈRITAS can be used pure or diluted up to 1:5 .

Pure to eliminate old protections or to solve problems during the application of a coating. 

Diluted 1:1 as a control in the spot test phase while diluted from 1:3 to 1:5 as a normal post-polishing check.

In case of pure product, spray #VÈRITAS on a microfibre cloth and then wipe the surface.

In case of diluted product, spray it directly on the surface. Avoid dispensing the pure product directly on the bodywork.

To check the health of the coating, after washing the car and with the car wet, spray VÈRITAS on the surface of the hood from a distance of 60 cm, then rinse with a jet of water.

If used pure, spray the product on a short-haired microfiber cloth and then pass it over the affected area, taking care not to apply any pressure, preferring linear movements and then finish with the dry side of the cloth.

If used diluted, spray the product on the affected area and then with a microfiber cloth without any pressure spread it on the surface, at the end finish the surface with the dry side of the microfiber cloth.

Do not use VERITAS on hot surfaces or under sources of heat , in the presence of surfaces painted with a single layer \ direct gloss system, avoid drying the product on the surface.