Adam's Salt, Mud and Grime Remover 16oz — deep-clean road contamination or prepare paint for fresh protection.
Adam’s Salt, Mud & Grime Remover is designed to do a deep-clean wash of a vehicle, using a more heavy-duty wash formula to help loosen and lift salt, dirt, road grime, oils, mud, and more, to then wipe away these contaminants with less effort. This results in a safer wash with less chance of scratching, since you won’t have to use as much heavy scrubbing to remove the grime. Salt, Mud & Grime Remover is a great option to use every few washes when you need that extra strength to bring back a nice, clean finish to a very dirty vehicle.
- Aids In the Removal of Salt, Grime, Mud, and Dirt
- Acidic Formula Helps Dissolve and Remove Contamination
- Contains Corrosion Inhibitors
- Safe on Ceramic Coated Vehicles
- Powerful Degreasing Properties
Instructions:
For best results, use a Foam Cannon or Foam Gun to pre-soak your vehicle.
- Prep two buckets with Grit Guards: (1) Wash bucket with 2oz of Adam’s Salt, Mud & Grime Remover and Wash Pad and (2) Rinsing bucket filled with clean water.
- Fill Adam's Foam Cannon or Foam Gun canister approximately
⅘ full with water.
- Pour 1-2 oz. of Salt, Mud & Grime Remover Shampoo into the canister.
- Screw Foam Cannon or Foam Gun barrel onto canister, shake well.
Turn the top knob all the way clockwise for maximum level of foam. For maximum suds when using a Foam Gun, we recommend NOT using a metering tip.
- Pre-rinse vehicle with pressure washer or garden hose to remove
heavy dirt, mud, and other debris from the surface.
- Attach Adam’s Foam Cannon canister and sprayer to the pressure washer wand. For use with a foam gun, attach to a hose nozzle.
- Squeeze the pressure washer handle or Foam Gun nozzle to spray a clinging foam solution onto the vehicle.
- Allow Salt, Mud & Grime Remover to pre-soak the vehicle, helping to loosen and lift dirt for a few minutes as it drips down the vehicle surfaces. Perform a Two-Bucket Wash, then disconnect the Foam Cannon or Foam Gun, and finally rinse and dry
the vehicle following Adam’s instructional videos.
Application notes
Use this stronger wash when the job calls for it. Review existing wax or sealant protection after cleaning and refresh it where needed.
How to use
- Work on cool panels in shade. Rinse loose grit from the vehicle and prepare a clean wash mitt and separate rinse bucket.
- Measure the shampoo for your bucket or foaming equipment using the directions for this formula. Foam output varies with dilution, water hardness and equipment.
- Wash from the upper panels downward with light pressure. Rinse the mitt frequently and use separate tools for wheels and lower grime-heavy areas.
- Rinse thoroughly before the shampoo dries, including mirrors, seams and trim. Dry with a clean microfiber drying towel or a suitable vehicle dryer.
Aftercare and maintenance
Rinse wash mitts and buckets after use and allow them to dry. Flush foam equipment with clean water so dried shampoo cannot clog its internals. Maintain paint protection as needed and remove bird droppings or road contamination promptly.
Does more foam mean the paint is clean?
Foam helps distribute shampoo and loosen contamination, but it does not establish that all dirt has been removed. Inspect the finish and use a careful contact wash when needed. Never let foam dry while waiting for it to do more work.
Complete your detailing routine
Choose compatible products for the next step of your detail:
