new generation solvent free hybrid polymer coating specially formulated for leather, vinyl and synthetic leather. A formula designed to repel clothing dyes, dirt, pen marks, rubber discolouration from child seats, cracking and fading by UV rays.

• Suitable for all automotive leather/vinyl/pu and vegan leather. Test before use on aniline/porous leather
• Very easy to apply, only one layer required
• Repels dirt and prevents discolouration, protects against friction damage and cracking caused by UV rays
• Free of ceramic & other nano particles
• Solvent free
• Microplastic free
• Easily withstands wet brush cleaning
• Is detergent resistant - it can be cleaned and continues to protect
• Outstanding dye resistance even under moist conditions!
• Makes cleaning a coated surface extremely easy, even after long use
• Has no health or hazardous warning label
• Safe for all top-coated leather and synthetic surfaces

Instructions:

• Make sure the surface is clean and dry. Test on an unseen area before use. 
• Spray a small amount of product on the applicator included and apply on to the surface evenly in a circular motion. Ensure you coat the whole seat especially high traffic areas. Allow to dry naturally for 15-20 mins. Then use a microfibre cloth to gently buff to an even, matt finish.
• If needed, repeat the application to ensure adequate and even coverage. Two thin coatings are, generally better than one thick coat. 
• In case of streaking after drying, re-wet the applicator slightly with the coating and apply a thin layer to the affected area and buff immediately.
• Leather imitations (e.g. Vegan leather): the coating may first appear uneven before drying, but the light buffing after the drying time will spread and even out the coating.

FAQs:

Q: How long will it last?
A: Over 12 months / 25,000 km under normal conditions (Outperformed all other tested ceramic coatings in dry and moist long-term testing).

Q: How to store the product after use? What is the shelf life once opened?
A: Store over 5°C and below 35°C. Frost sensitive.

Q: Can I apply multiple layers?
A: One layer is enough. Two or more layers increases the protective function.

Q: Can I top it off with additional sealant/wax?
A: Yes, we recommend using Geist. Dye & Friction Blocker for maintenance purposes.

Q: How long does the product need to dry/cure?
A: As it is a water based product the vehicle can be used after the coating has dried and surface is touch dry. It takes 48 hours for the coating to reach full strength.

Q: How to maintain a vehicle coated with this product?
A: We recommend using Geist. Rapid Leather Cleaner followed by Geist. Dye & Friction Blocker (available together in the Geist. 3 Minus Care Kit). For very light cleaning, Geist. Surface & Screen Cleaner can also be used.

Q: Can it be removed?
A: Yes, if needed (e.g. if a surface repair is needed) clean thoroughly using Geist. Rapid Cleaner PRO & brush (twice) to remove the coating.

Q: Is it a breathable coating? Why? How?
A: Yes, microscopic pictures show that even small pores remain open. The flexible micropolymer lets air and moisture penetrate the surface.

Q: How and where do other products fit in?
A: Most protected automotive leathers require a light cleaning occasionally for hygienic reasons. Sweat, pollution and spills (sugar, fats) can easily be removed by wiping over with Geist. Rapid Cleaner.

Q: What if I still get stains?
A: If any stains do eventually penetrate, Geist. Repel makes removal easier e.g. Geist. Dye and Ink Remover is a solvent free product that removes many coloured stains without damaging the surface.

Q: Will it cause white seats to go yellowish?
A: No, Geist. Repel is stable even under strong sunlight conditions as it contains an effective UV filter.