Application Instructions
1. Before applying Nano-Resin MX, paint must be prepped. Clay and polish your paint with a light compound and a random orbital machine buffer. If your paint is heavily scratched, paintwork correction may be required.
2. Remove any residual matter from polishing using a panel wipe.
3. Spray Paint Coating Builder onto a panel or small area. Wrapping the suede cloth around the foam block applicator, spread the Paint Coating Builder in vertical overlapping lines down the panel, followed by horizontal overlapping lines.
4. Let sit 2-3 minutes, then remove with a microfiber towel. Repeat steps 3-4 until all desired paint surfaces are coated.
5. Wrap a new suede cloth around the foam block applicator and use the included pipette to apply a line of Nano-Resin MX down the center of the cloth.
6. Start by applying Nano-Resin MX in vertical lines down the panel. After you've covered your panel with vertical lines, go back and repeat with horizontal lines. This crosshatching will ensure full coverage. Avoid getting the product in panel gaps.
7. Let the product sit on the surface for 30 seconds to a minute. Wipe panel with a clean, dry, microfiber towel.
8. Repeat steps 5-6 on each panel until your entire vehicle is protected. Reapply several drops of Nano-Resin MX to your applicator every few panels or as needed.
9. Allow coating to cure undisturbed for one hour. After, if product is left over, re-apply to high impact areas.
Dr. Beasley's Suggests:
• Do NOT apply Nano-Resin MX in direct sunlight. Do not allow this product to freeze during storage.
• If applied in temperatures less than 65-70° the product may need more time on the surface before removal. In warmer, more arid climates Nano-Resin MX may need less time.
• Inspect the vehicle in natural light for a better view of high spots.
• Keep vehicle completely dry between applications and for at least 1 hour after final application. After 1 hour the vehicle can be exposed to light rain without affecting the bonding process.
• Coating will cure after 24-48 hours, after which it is fully bonded to the paintwork.
• Avoid washing the vehicle with soap for 7 days after application. After this follow our prescribed maintenance regimen, including the use of
AdvanceCoat: Gloss as a coating reinforcer.
• Use entire bottle when applying. Do not re-cap opened bottle for future applications.
