Two Buckets and a Green Boxster on Rinseless Wash Day
If I could move one thing before the Boxster wash starts, I'd turn both buckets round until I could read them from the car. WASH and RINSE are beautifully clear in GYEON's photograph. From directly overhead all I see is a white rim and a reflection of the sky. By the time I've come round the front wing with a wet mitt in my hand, the two can look remarkably alike. A big word printed on a bucket does me very little good if the word is facing the hedge.
I'd leave the rinse bucket a little closer to the car. That's the first place my hand ought to go when it comes away from the paint. The wash bucket sits beyond it and the clean towels go up on a stool, well clear of anything that splashes. If somebody stops to chat halfway through, I can pick up where I left off without trying to remember whether I was using left for clean and right for dirty. The order I meet them in does some of the remembering for me.
What I put in the wash bucket
On this driveway I'd use GYEON Q²M ECO Wash at its rinseless wash dilution. It can also be mixed for waterless cleaning or used as a drying aid. Those are different jobs with different amounts of concentrate. I'm measuring this one for a bucket and wet wash media, then drying the clean panel before I move on. The second bucket gives me somewhere to rinse the mitt. The word rinseless describes what I do with the clean panel at the end. It doesn't mean I have to put a dirty mitt back in the good solution.

The arithmetic is easy enough if I decide how much water I'm actually carrying first. Ten litres is a convenient example. At one part product to 256 parts water, 10,000 millilitres of water divided by 256 calls for about 39 millilitres of ECO Wash. At one to 150 it takes about 67 millilitres with that same ten litres of water. That's the manufacturer's rinseless range. I follow the directions on the bottle in my hand and measure in a marked cup. I don't try to work it out by counting seconds while a glug of concentrate escapes over the rim.
The size moulded into the bottom of the bucket is how much it can hold. It tells me nothing about how much I've put in today. If I'm only filling it halfway because it's a long walk from the tap, I use the water level I measured. I like a permanent mark at a useful fill line. Draw it while an accurately measured amount of water is sitting in the bucket and it will still be there the next time the kitchen jug has mysteriously migrated back to the kitchen.
Before a wet mitt meets green paint
I'd take a walk to the Boxster's back wheel before deciding it's a rinseless day. The top of the bonnet can be dusty while the lower door has a strip of grit all along it. I want to know about that strip before I touch the easy half of the car. A light film is a reasonable job for a properly mixed solution and clean media. If there are gritty clumps, mud or a winter's worth of sand behind the wheel, I'd arrange a thorough pre-rinse or take it somewhere I can wash it properly. More concentrate doesn't change the size of a grain of sand.
Once I'm satisfied with the condition of the paint I soak the mitt and wet the section I'm about to work. I like to start on the side of the bonnet nearest the wash bucket. There's a temptation with a car this low to reach right across and be finished with it in one go. Try that reach with an empty hand first. Somewhere past the middle my belt is over the wing and the zip of my jacket is hanging about an inch above the green. I can walk to the other side in less time than it takes to find somewhere to put the jacket.

I let the wet fibres rest on the paint and move them over a short run I can see. At the end I lift the mitt and look at the side that's just been down. A green bonnet can hide a surprising amount of grey dirt. It shows up quite well on the face of a pale mitt. If I see a little stone or a stubborn dark piece caught in the fibres, I switch to a clean mitt. Dunking it three more times doesn't prove that whatever was caught has come out. There's a spare on the stool for exactly this moment.
For ordinary light dirt I rinse the used mitt in the separate bucket, check it and reload it with the wash solution. If the rinse water gets filthy early, I'd stop and change it. That can feel wasteful on a day when I've chosen a low-water method, until I think about the reason for carrying a second bucket in the first place. I don't want to rinse a mitt in muddy water and convince myself the whole arrangement is still doing what it was set up to do.
Where my drying towel waits
The drying towel follows the wash mitt fairly closely. I finish the wet section of bonnet, put the mitt down in its proper place and dry the clean area while I can still see the boundary. On a Boxster the centre of the bonnet makes an obvious division. Farther round, a door gap or a change in the shape of the wing does the same job. In the time it takes to wash the passenger door the sun can come round the edge of a roof. I'd shorten the sections if what I'm washing starts to dry faster than I can follow it.
A second pair of hands is nice here if we agree where the wash stops. I'd take the mitt and have the other person dry the panel I've just finished. I like to say the name of the panel out loud as I hand it over. “Bonnet's yours” is easier to understand over the sound of a bucket being moved than pointing vaguely at one green corner of a green car. In return I want to hear about a dirty streak on the towel straight away. That's a reason for us to look at that section together before either of us carries on.
On my own I'd rather do a smaller piece well. I'd keep the drying towel folded when I get to the lower doors, taking care that the hanging part doesn't drag along the paving. If it touches the ground I retire it. I also leave the lowest, dirtiest areas until the cleaner bodywork is done. I can put a fresh mitt on a rocker panel and send it straight to the used pile without having to remember later whether that was the mitt I meant to keep away from the bonnet.
There's a variation I like when I'm travelling and the second bucket is occupied carrying something else. I can work with multiple clean wash cloths, keeping a used one out of the clean mix once it's touched the car. That takes more laundry and a proper place for the used cloths. For the Boxster in the picture, with room on the drive for both buckets, I'd take the arrangement I can see. Either way, the decision I make at the end of a pass matters more to the finish than the number of containers I own.
At the end I'd pick up the towels before tipping anything away at an appropriate drain. Look back at the picture and imagine stepping backwards over one bucket while trying to save a clean towel from the other. All that open driveway suddenly seems a bit small. I like to put the lids back on the empty buckets and nest the clean measuring cup where I can find it. When the next wash comes round, the only puzzle I want to have left is which way to turn the labels.
Photography by GYEON.