Down by the Wheel With GYEON WetCoat and a Porsche to Rinse
The photograph I'd put on the garage wall is the one taken from paving-stone height. There's a Porsche at the far end of the frame getting rinsed, but my eye goes to the ground first. I can almost feel the damp patch I'd have on one knee if I'd taken the picture. That's a good height from which to notice a strip of soap underneath a sill. It's a terrible height at which to discover that the pressure washer is on the other side of the car.
We start much higher up, at the bottom of the windshield. A little orange bottle stands beside the green paint. I can see long tracks on the glass where the water has a fairly straight journey to the wiper. On the bonnet, drops sit in separate little groups. I'd enjoy that view for a moment before moving the bottle. Once the rinse is underway I'd give it a place on the ground or on a cart. I don't want it sliding across the bonnet just as I've got one hand on the lance.
The orange bottle at the end of the wash
This is GYEON Q²M WetCoat, the ready-to-use spray sealant. I use it straight from the bottle on a freshly washed, wet exterior, then rinse it off immediately with strong water pressure. No mixing cup for this one. I'd check the name if someone handed me a little blue bottle of WetCoat Essence instead, because that's the version that needs diluting. It's the difference between a product that can travel round the car with me right now and one I'd take back to the bench.
Before that point I'd make sure we've actually washed the Porsche. From a standing position, a green car can look impressively clean after a quick pressure rinse. Drop down towards the sill and there's often still a line where the road has laid a fine dirty film across the paint. If I still see that line, I get the shampoo and clean wash media out. I'd rather rinse a little more soap away now than dry that film with a towel later and wonder why the towel came away grey.
I also want the sun far enough off the working panel that I can keep the whole piece wet. The light makes the wheel photograph sing, but I'd do the treatment in shade on cool surfaces. A quick check is to wet the area and watch the edge while I'm sorting the hose. If it is already starting to vanish, it's too warm or too windy for the size of section I've chosen. I can change position, wait, or come back after supper when the house casts a longer shadow.

Looking through the spokes
Up close the silver wheel and red caliper seem to take up the entire driveway. I can see why the photographer stopped there. From this angle the open spaces in the wheel matter just as much as the painted spokes. My concern during a rinse is what water and cleaner have done in the spaces I can't see from directly in front. I come round a little to either side and check the corners of the spokes. Old wheel-cleaner residue or suds hanging on in a recess get rinsed away before I think about finishing the exterior.
If the wheel itself is hot from driving, I let it cool before cleaning it. I use the wheel tools on the wheels and put them away before the paint towels come out. The brake dust hiding behind a handsome silver spoke isn't something I'd like transferred to the green wing. On a car where the wheels take a while, I'd do that cleaning early in the wash. By the time I'm on the ready-to-use sealant, I want the remaining task to be simple enough that I can keep my attention on the piece I've just sprayed.
With the Porsche wet, I'd start on a manageable panel and keep the rinse immediately to hand. I apply the small amount called for on the bottle, then pressure-rinse that section thoroughly straight away. I don't go around misting four wings before returning to the first. I don't spread it with the wash mitt either. Putting the clean mitt away before getting the orange bottle out is my uncomplicated way of remembering that the contact part of this job is over.

From the low view behind the car, I can see water coming off the back. That tells me water made it to the back. It doesn't tell me whether I've rinsed the entire section beside the lamp, the lip above the number plate or the return around the corner. I shift my feet so I can see the limits of the panel, follow them with the rinse, and look for the next place the runoff goes. A whole lot of impressive spray hanging in the air isn't quite the same thing as coverage.
The bit under the sill
This is where I'd want my helper. One of us can work the rinse while the other keeps the hose away from the paint and the edge of the wheel. I'd have the person with the bottle stop after a single section. A little conversation makes the job easier. “Rear wing done” is enough. I'd much rather say it out loud than try to tell which part of a uniformly wet green car somebody else treated while my back was turned.
If a patch looks oily after the rinse, I wouldn't put another spray over it to see if the two patches even out. Too much WetCoat is one possible cause of an uneven finish. I'd go back to the maker's guidance, wash the affected piece again and reassess it. When I'm ready to reapply, I want a cool, wet panel, less product and a prompt, thorough rinse. I'd do that one piece instead of starting over on the entire Porsche because of a hand-sized patch next to one lamp.
The drying towel is for the clean, rinsed car. I'd begin with the broad panels while the water is still there to pick up. Then I'd give the car a moment while I move the washer hose out of the way and take another look along its lower edges. A fresh run from the corner of a lamp or the underside of the mirror is just water to catch. There's no need to treat the section again every time a hidden droplet makes it to daylight.
What I like about this finish on a driveway is how neatly it fits into an ordinary wash. I can add some water repellency without setting aside a separate evening for a hand-applied coating. If I want to judge it the next time I wash, I'll look at how water behaves on clean paint. A dirty lower panel and a clean bonnet can behave quite differently even if I treated them a minute apart. I'd take that into account before deciding the bottom half of the car needs another application.
I'd keep the low photograph as a reminder to crouch down once before putting everything away. From up by the windshield the car looked finished several minutes ago. From beside the wheel I can still see one small drip under the sill and a bend in the hose that's about to catch my ankle. I can deal with both while I'm down there. Then I'd take my damp knee and my clean Porsche up to the dry end of the drive.
Photography by GYEON.