The Long Way Home: An Audi RS3 Wash with GYEON
CARZILLA JOURNAL · GYEON WASH DAY
Back home, bucket out.
A white RS3, a little attention up front, and glass worth looking through again.
4-minute read · Audi RS3 · Photos by GYEON
Looking through this GYEON photo set, I keep picturing the same afternoon: take the Audi RS3 out for a drive, choose the longer route home, then find an excuse to stay outside with it for another hour. White paint, dark glass and that big black grille look especially good against the old brick building. I’d probably spend a few minutes admiring it before getting the hose out.
The photos have me thinking about the everyday side of Audi RS3 detailing. After a decent drive, the front bumper and the glass are where I’d look first. A few stubborn insect marks can make the nose look untidy, while a film on the windows takes some of the pleasure out of a freshly washed car. Those two jobs would bookend this wash.
Starting with the evidence up front
On white paint, the little specks have nowhere to hide. I’d crouch down by the bumper and look before touching anything. It’s tempting to pick at a dried-on mark or give it a quick rub, especially when the rest of the panel looks fairly clean. This is the moment I’d put the wash mitt down and let a pre-wash cleaner help.
GYEON Q²M Bug & Grime is made for insect residue and stubborn road grime before the main wash. With the Audi in the shade and the panels cool, I’d apply it to the affected areas, give it the brief working time on the bottle, then rinse thoroughly. I’d keep each section small enough to watch, so the cleaner never dried on the paint or trim.


I like the idea of easing the dirt off before the mitt gets involved. If a stubborn patch remained, I’d inspect it and repeat a gentle, targeted treatment if needed. A mark that remained after cleaning might need a different approach; scrubbing harder wouldn’t be my answer. For me, the satisfying part would be seeing the front end come clean without turning it into a wrestling match.
The quiet bit in the middle
Then I’d move into the normal wash: a thorough pre-rinse, a suitable car shampoo, a clean wash mitt and light passes over the body. Starting high and leaving the dirtier lower panels until last gives the afternoon a comfortable rhythm. Rinse the mitt, load it again, move along. No need to rush around the whole car with shampoo drying behind me.
After the final rinse, I’d dry with a clean microfibre towel, then catch the lingering water around the mirrors and window edges. Those are the drops that seem determined to appear just after you’ve put everything away. I’d give them a minute while sorting out two clean towels for the glass.
The glass is the job I’d save a little energy for. You get to enjoy that part from the driver’s seat.
Saving the clear view for last
The blue GYEON Q²M Glass Cleaner bottle fits this stage perfectly. It’s a glass cleaner for dirt, oily film and smudges, and I’d use it to finish the windows once the main washing and drying were done. Clear glass makes the whole car feel more finished to me, even when you’re only looking at it from the driveway.
On cool glass, out of direct sun, I’d spray a small amount onto a clean, short-pile microfibre towel and work across one window at a time. Then I’d switch to a dry towel face, or the second towel, for the final wipe. Applying it to the cloth also gives me more control around the trim and inside the car.


I’d check from a couple of angles before moving on. A window can look clear straight ahead and reveal a faint smear when you lean to one side. If that happened, I’d reach for a fresh towel face and make another light pass. The aim is simply clean glass, with the oily film and leftover cleaner gone.
I’d save one clean glass towel until I’d sat in the driver’s seat. That’s usually where a missed streak makes itself known.
Getting ready for your next wash? Find the GYEON products featured here through the CARZILLA links in the story.
Photography supplied by GYEON. A wash-day story inspired by the Audi RS3 photo series.