CarPro FlyBy30 20ml Kit

CarPro FlyBy30 20ml Kit

Brand: Carpro

Product Code: 333

Availability:In stock

$20.95 USD 20.95

3%+ Discount with 3+ of the Same Item

CarPro FlyBy30 20ml Kit


  • (1) 20ml bottle of FlyBy30

  • (1) Applicator Block

  • (2) 4" Microfiber Suede Applicators

  • (1) Ceriglass Polish

FlyBy30 is THE answer to protecting the windshield and exterior glass surface of your vehicle.  With FlyBy30 new state of the art materials were composed to create a strong coating on glass windshields and windows.  FlyBy30 resists the friction and abrasion from road rash, wipers, dust, car washes, harsh cleansers, and the environment.  With a high water droplet contact angle and low sliding angle FlyBy30 promises fast repellency and glass easily cleared from rain, ice, snow and bugs.


  • Ease of use

  • Value: Estimated consumption per complete car windscreen and side windows is 10ml

  • Perfect Clarity: No haze, smears, or stains

  • Provides safe, and high visibility driving in poor weather conditions

  • High water drop contact angle (112 deg.) & low sliding angle (15 deg.) promise fast repellency.

  • Water repellency on windshields will last minimum of 6~8 month (1 season). Beyond that rain drops will continue to repel but at higher speeds.

  • FlyBy30 repels water drops starting at 30 to 40 mph, and allows you to have clear vision with safe driving. * Speed varies based on windshield angle, average tested on 45 deg. Angle)

  • FlyBy30 can be used on all car glass allowing safe driving in the rain with clear vision all around.


  • High water droplet contact angle (112 deg.)

  • Low water droplet sliding angle (15 deg.)

  • Rain repellency starting from 30-40 mph

  • Durability: 6-8 months Min.


  • *Do not apply to a wet windshield or it may cause damage to the surface.

  • Polish your glass using Ceriglass by hand or machine. If scratches are present use machine.

  • Wipe off residue

  • Clean surface well with Eraser

  • Shake Flyby30, pour a few drops of FlyBy30 on the suede applicator and apply in criss-cross all over the surface.

  • Let cure for a minimum of 1 minute, usually about 2-3 and wipe it off with a dry clean MF towel.

  • If waiting was too long and surface is hard to wipe off, repeat the application again on that area.

  • Heat up the glass to 160 deg F for 5 min. using IR light or heat gun. (Baking the coating will release the car to drive in the rain without 12H drying time)

  • If surface was not heated allow to dry for more than 12 hours, in order to make the coating adhere firmly to the windshield.

  • Thoroughly clean the wiper blades with Eraser.


  • Apply Reload to wiper blades.